EASY TO USE INSTRUCTIONS:

Preparation:

First clean the plate, with an alcohlic wipe/ or alcohol.  Try to avoid using soap or washing up liquid. (Clean the item, even if it is new, as surface contamination may inhibit adhesion).

For metal finishes; It is important that the plate is thoroughly cleaned and that any grease is removed.  Any oxide formation should be removed first with a proprietary cleaner and then cleaned with neat detergent and rinsed in clean water.

Applying:

Using the fingers mix a little water into the glue on the adhesive side of the disc and slowly agitate with your finger to activate the glue. Leave for 5-10 minutes until the glue becomes "tacky".

Apply the disc to the back of the plate (ensure the hook is in the correct position for plate design). Press down firmly and rub well to expel any air.

Leave to dry overnight. (24hrs to be on the safe side)

Before hanging, test the strength of the adhesion by pulling firmly on the ring.

Removal:

The Disc removes completely in warm water and will not remove back stamps, glazes, or any other markings.



Information kindly provided by the manufacturer.
Disc Plate Hanger
Plate-stand.co.uk is a trading division of 'Gemolade Limited'.  Registered in England No. 9003667. 
Registered Office: 161 Bannerdale Road, Sheffield, S7 2DS.  Tel: 0114 2494940   VAT: GB 228 8863 62